Name *

First Name

Last Name

Before installing the Termistop, the installer must remove or reposition any tape, insulation or obstruction from the service penetration. *

True

False

When sliding the Termistop Flange over the pipe, the Termistop is positioned in the middle of the slab depth as the clamp is tightened. *

True

False

Because the Termistop is made of stainless steel, contact with the steel reinforcement is allowed. *

True

False

Once installed on the pipe, the Termistop Flange skirt must be lifted to approximately 45 degrees above horizontal. *

True

False

The first step of installing a Termistop Bathtrap is to press the clamp to the mesh and tighten the clamp at the top of the pipe. *

True

False

When cutting the mesh for the Bathtrap, the installer must cut an "X" at the top of the clamp, making sure to cut with the grain of the mesh. *

True

False

Once the mesh is cut for the Bathtrap, the installer folds each tab only once before he is ready to slide the Bathtrap in place. *

True

False

After the Bathtrap profile is flattened to the pad, the edges must be folded up to insure they "key in" to the concrete. *

True

False

Any material removed from a penetration (Tape, Insulation, etc), must be replaced to it's original condition and position after Termistop installation is complete. *

True

False

When the final penetration is completed, the installer should pack up his/her tools and leave the jobsite. *

True

False